Precor Experience 700 line Series Service Manual page 107

2. Reinstall the MC by sliding the left side base flanges under the two left preinstalled
loosened fasteners. Then install the two right side fasteners and fully tighten all four
fasteners.
3. Route cables and secure using the frame cable clamps. Recheck all cable MC con-
nections and make sure that the cables have freedom of movement and clear of any
frame or component edges that could pinch or damage the cable wires.
1
4. Plug in the power cord and switch the power ON.
5. Verify the MC status light is green. If the status light is yellow, reset the status light as fol-
lows:
P10, P20, and P30
a. Clear the Error Log of any stored error codes: Hold down PAUSE to access the
Error Log > select OK to view error codes, and then hold down QUICK START
to clear the Error Log of all error codes.
b. Clearing the Error Log resets the ASL and MC status lights. Verify that the ASL
status light is blue and the MC status light is green.
P62, P80, and P82
a. Reset the ASL and MC status lights: Access the service Settings menu
(5,1,7,6,5,7,6,1), select Maintenance > Operating Condition > and the Reset
softkey to reset the ASL and MC status lights. Verify the following Maintenance
menu parameters:
Recommended Action: None
l
Operating Condition: Normal
l
Active Status Light: Solid Blue
l
b. Visually verify that the MC status light is now "green" and the ASL light is "solid
blue".
c. Repeat selecting the Back softkey to exit and return to the "Welcome" banner
home page.
6. Reinstall the hood cover, see
7. Do the Operation Verification tests (see
to service.
1
Device power cord connector or electrical cable male connector that is inserted into an elec-
trical receptacle "outlet" (also called the plug-in).
"Hood Cover Replacement" on
"Operation Verification" on
5 Replacement Procedures
Motor Controller (MC) Replacement
page 60.
page 16) and return
Page 99