Precor Experience 700 line Series Service Manual page 131

3. Center and square the running belt onto the Take-up and Drive rollers and tension to
specification, see
verify tracking or apply power at this step in the process, the running belt tracking will be
verified after the Drive Belt is installed.
Note: 1) The running belt tension adjustment is performed with the drive pulley:
removed.
2) Tension the running belt to specification prior to adjusting the Drive Belt ten-
sion.
4. Install the drive belt. Place the Drive Belt onto the Roller pulley and then walk the belt
onto the Drive Motor pulley.
5. Reinstall the Dust Guard and secure using the two #3 Phillips and two 7/16" hex head
fasteners. Make sure to insert the left Dust Guard bracket through the Drive Belt pulley
before securing the fasteners.
6. Make sure the Drive Belt pulley alignment is correct and then tension the Drive Belt to
specification. see
7. Connect the power cord and switch the ON/OFF circuit breaker to ON.
8. Operate the treadmill and verify the running belt tracking, see
and Tracking Adjustment" on
9. Reinstall the hood cover, see
left/right Landing Trim covers, see
10. Do the Operation Verification tests (see
to service.
"Running Belt Tension and Tracking Adjustment" on
"Drive Belt Tension and Alignment Adjustment" on
page 43.
"Covers and Panels Replacement" on
"Covers and Panels Replacement" on
"Operation Verification" on
5 Replacement Procedures
Drive Roller Replacement
page 43. Do not
page 39.
"Running Belt Tension
page 58, and
page 58.
page 16) and return
Page 123