Take-Up Roller Replacement; About; Procedure - Precor Experience 700 line Series Service Manual

Take-up Roller Replacement

About

This procedure provides instruction to remove and replace the Take-up Roller.

Procedure

Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and
2. Remove the hood cover, see
left/right Landing Trim covers, see
3. Remove the running belt tension by loosening the left and right 5/16" hex key Take-up
roller tension adjustment bolts. Alternately loosen the left and right adjustment bolts in
1/4 turn increments so that the running belt tension is evenly removed. Only use hand
tools and not power tools to adjust tension.
CAUTION: Only use hand tools to adjust tension. Power tools can easily over
and/or under tension causing damage to the belt and/or tension hardware
mechanism.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
1
unplug the power cord.
"Covers and Panels Replacement" on
"Covers and Panels Replacement" on
5 Replacement Procedures
Take-up Roller Replacement
page 58, and
page 58.
Page 124