Precor Experience 700 line Series Service Manual page 54

8. Attach a running belt tension gauge on each side of the running belt opposite each
other. Place the gauges so that the trim landing mounting brackets do not interfere with
the gauge movement.
9. Slide the gauge head to set the dial needle as close as possible to 3.0 (0.0%) and clip
the gauge onto the belt edge. Then rotate the gauge dial face to fine adjust the needle to
precisely 3.0 (0.0%)
Note: Setting the gauge to a 3.0 reference value centers the gauge head travel allow-
ing +/- movement without impeding travel.
10. Alternately tighten the right and left running belt tension adjustment bolts in increments
of 0.2 (0.2%) dial divisions so that the belt is evenly tensioned to the manufacturer spe-
cification:
a. Incrementally and alternately tighten the left and right adjustment bolts entail
each gauge dial reaches a value of 3.0.
b. Tighten the right adjustment bolt to dial setting 3.1, then the left adjustment bolt to
3.2.
c. Tighten the right adjustment bolt to dial setting 3.3, then the left adjustment bolt to
3.4.
d. Tighten the right adjustment bolt to dial setting 3.55 (0.55%), then the left bolt to
3.55 (0.55%).
ammeraal brand running belt tension (gauge/percent)
Forbo brand running belt tension (gauge/percent)
Notes: * Referenced to gauge reading 3.0 (0.0%)
Running Belt Brand
4 Adjustment Procedures
Running Belt Tension and Tracking Adjustment
Specification
[[[Undefined variable Spe-
cifications.TRM14-Amer-
aalRunBeltTension]]]*
3.55 (0.55%)*
Page 46