2. Set the Take-up roller into the left and right mounting brackets.
3. Connect the power cord and switch the ON/OFF circuit breaker to ON.
4. Center and square the running belt between the Drive and Take-up rollers. Tension to
specification and verify tracking, see
on
page 43.
5. Reinstall the left and right Landing Trim covers, see
on page 58
and hood cover, see
"Running Belt Tension and Tracking Adjustment"
"Covers and Panels Replacement"
"Covers and Panels Replacement" on
5 Replacement Procedures
Take-up Roller Replacement
page 58,.
Page 126