Removal Instructions
1. Switch the power OFF and
2. Remove the hood cover, see
left/right Trim Landing covers, see
3. Remove the Take-up Roller, see
4. Remove the Drive Roller, see
5. Remove the four 5/32" hex key bolt and washer rear deck fasteners. These fasteners
attach to the left and right rear deck pivot assemblies. The 1/2" fastener nuts are press
fit into the bottom of the deck pivot housing, be aware that the nuts can fall from the hous-
ing as the bolts are being removed. If this happens, reinsert the nut into the pivot hous-
ing. Retain fastener hardware for installation.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Running Belt and Deck Replacement Procedure
1
unplug
the power cord.
"Covers and Panels Replacement" on
"Covers and Panels Replacement" on
"Take-up Roller Replacement" on
"Drive Roller Replacement" on
5 Replacement Procedures
page 58, and
page 58.
page 124.
page 119.
Page 129