Precor Experience 700 line Series Service Manual page 44

METRIC
MAINT COUNTER
U-BOOT SW
U-BASE SW
METRICS BOARD SW
SER NUMBER
USAGE LOG
ERROR LOG
TREADMILL
(1)
MAINTENANCE
(1) Only available on ASL equipped models.
(2) TRM800-14, TRM700-16 models
3 Standard Service and Diagnostics Software
Hours remaining until maintenance is required (initializes
to 250 hrs, estimated hours for 1 month use).
Press/Hold the PAUSE/RESET key to reset the counter.
The console Upper Boot software version information.
The console Upper Base software version information.
The console Metrics board software version information
Displays the model and serial number of the machine. The
base serial number can be set using the WinCSAFE com-
puter software. The factory default is NONE.
Displays the type of workout programs the users are
accessing most frequently.
Table of stored error event codes.
TIP: You can quickly access the Error log by holding down
the PAUSE key. Will show the STUCK KEY message
when there are no logged error codes.
Used to monitor and reset the 1000 mile belt cleaning main-
tenance reminder. Mileage counter starts at 1000 miles
and decreases to 0 miles which triggers a blue pulsing ASL
light indicating it's time for belt cleaning maintenance.
The maintenance counter and ASL light is reset as follows:
P10/P30 console
1. Select Treadmill Maintenance.
2. Press and hold QUICKSTART until 1000 Miles is dis-
played. The ASL light is also reset.
3. Exit the menu by pressing BACK or PAUSE/RESET.
P62, P80, and P82 consoles:
The maintenance reminder counter reset "Maintenance
Due" parameter is located in the Maintenance menu:
1. Access the service diagnostics (5,1,7,6,5,7,6,1).
2. Select Maintenance page.
3. Select Next Maintenance Due page > Reset.
Note: On P62, P80, and P82 the belt cleaning reminder
ASL Blue flashing state can be switched ON or OFF,
select Maintenance Reminder > ON/OFF.
Information Display (65)
DESCRIPTION
Page 36