Precor Experience 700 line Series Service Manual page 159

1. Connect the power cord and switch the power ON. Be aware that switching the power
ON will cause the incline platform to move and return to the level "0" position. If you are
using the side access method, see
upright the treadmill.
WARNING: Keep hands and appendages clear of the incline platform
assembly before switching power ON. Switching power ON will cause the
incline platform to move to the level "0" Home position.
2. Access the service menu (51765761) and select the INCLINE TEST. Increase the
incline level enough to lift the treadmill frame off the supports.
3. Remove the supports and clear any other items that might either block the treadmill
from lowering or may be damaged as it lowers.
4. Lower the incline to level "0".
Operation Verification
5. Verify the treadmill incline operation from minimum to maximum levels.Make sure that
there are no active Incline function related error codes.
6. Reinstall the left and right trim side covers see
page 58.
7. Reinstall the left/right trim landing covers, see
page 63.
8. Reinstall the hood cover, see
9. Do the Operation Verification tests (see
to service.
"Side lift platform assembly access" on page 53
"Covers and Panels Replacement" on
"Trim Landing Covers Replacement" on
"Hood Cover Replacement" on
"Operation Verification" on
5 Replacement Procedures
Lift Platform Replacement
page 60.
page 16) and return
Page 151
to