Precor Experience 700 line Series Service Manual page 86

1. Remove the hood cover, see
2. Use a 1/4" socket to loosen the right side power cord cable clamp fastener. Then loosen
the inner cable clamp fastener until the clamp can be slide over the power cord plug.
Then disconnect and remove the power cord. In some cases the inner clamp fastener
may need to be completely removed. Retain fastener hardware for installation.
Installation Instructions
1. Connect the replacement power cord into the power cord AC input assembly.
2. Position power cord cable clamp over the power cord plug and fully tighten the clamp
fasteners.
3. Reinstall the hood cover, see
4. Connect the power cord and switch the ON/OFF circuit breaker ON.
5. Do the Operation Verification tests (see
to service.
"Hood Cover Replacement" on
"Hood Cover Replacement" on
"Operation Verification" on
5 Replacement Procedures
Power Cord Replacement
page 60.
page 60.
page 16) and return
Page 78