TIP: Use (turn) the Drive Motor flywheel to make it easier to turn the motor pulley and
help walk the belt onto or off the Drive Motor and Drive Roller pulleys.
4. Reinstall the left side Dust Guard #3 Phillips fastener and fully tighten.
5. Make sure the Drive Belt pulley alignment is correct and then tension the Drive Belt to
specification. see
6. Connect the power cord and switch the power ON.
7. Operate the treadmill and verify the running belt tracking, see
and Tracking Adjustment" on
8. Reinstall the left and right trim landing covers, see
on
page 63.
9. Reinstall the hood cover, see
10. Do the Operation Verification tests (see
to service.
"Drive Belt Tension and Alignment Adjustment" on
page 43.
"Covers and Panels Replacement" on
"Trim Landing Covers Replacement"
"Operation Verification" on
5 Replacement Procedures
Drive Belt Replacement
page 39.
"Running Belt Tension
page 58.
page 16) and return
Page 111