Connecting An Nfx350 Device To A Management Console - Juniper NFX350 Hardware Manual

SEE ALSO
NFX350 Chassis | 24

Connecting an NFX350 Device to a Management Console

NFX350 device has a console port with an RJ-45 connector. Use the console port to connect the device
to a management console or to a console server.
Ensure that you have an RJ-45 to DB-9 rollover cable available. An RJ-45 cable with an RJ-45 to DB-9
adapter is provided with the device.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want to connect
your laptop or PC directly to the NFX350 device, use a combination of the RJ-45 cable and RJ-45
to DB-9 adapter supplied with the device and a USB to DB-9 male adapter. You must provide
the USB to DB-9 male adapter.
To connect the NFX350 device to a management console (see
Figure 28 on page 82):
1. Connect one end of the Ethernet cable to the console port (labeled CON).
2. Connect the other end of the Ethernet cable into the console server (see
management console (see
Figure 27: Connecting the NFX350 Device to a Management Console Through a Console Server
CON
To Console Port
(on device)
Figure 28 on page 82).
Console Server
Figure 27 on page 81 and
Figure 27 on page
PC
81
81) or