Upgrading The Modem Firmware On Nfx Devices Through Over-The-Air (Ota) - Juniper NFX350 Hardware Manual

NOTE: If a SIM card is installed in the second slot, then select the profile and configure the
radio access type for the SIM card in the second slot as well.
7. Configure the Ethernet interface as the primary interface, which connects to the wireless network.
Configure the dl0 interface as the backup interface.
user@host# set interfaces ge-1/0/2 unit 0 family inet address 192.168.2.1/24
user@host# set interfaces ge-1/0/2 unit 0 backup-options interface dl0.0
8. Verify the status of the wireless network and dialer interface:
user@host# run show modem wireless network
user@host# run show interfaces dl0.0
Upgrading the Modem Firmware on NFX Devices Through Over-the-Air
(OTA)
Over-the-Air (OTA) firmware upgrade enables automatic and timely upgrade of modem firmware when
new firmware versions are available. The OTA upgrade can be enabled or disabled on the LTE module.
OTA is disabled by default.
NOTE: When upgrading the software on the NFX devices, the LTE firmware is also upgraded if
the software contains a newer firmware version.
1. Enable OTA upgrade on the LTE module:
user@host > request modem wireless fota cl-1/1/0 enable
Set FOTA on modem succeeded
2. Initiate the firmware upgrade:
user@host > request modem wireless upgrade cl-1/1/0
Launch FOTA upgrade succeeded
94