Table of Contents
Advertisement
Figure 20: Front Panel Components of the NFX350 AC Power Supply
1
2
3
1
Input status LED
—
2
Output status LED
—
3
Fault LED
—
Figure 21: NFX350 AC Power Supply
To connect AC power to the device:
1. Squeeze the two sides of the power cord retainer clip and insert the L-shaped ends of the wire clip
into the holes in the bracket on each side of the AC power cord inlet on the rear panel. See
The power cord retainer clip extends out of the device by 3 in.
2. Locate the power cord or cords shipped with the device; the cords have plugs appropriate for your
geographical location. See
WARNING:
it or block access to device components.
3. Insert the coupler end of the power cord into the AC power cord inlet on the rear panel.
4
5
"AC Power Cord Specifications for an NFX350 Device" on page
Ensure that the power cord does not drape where people can trip on
4
AC power cord retainer installed
—
5
Ejector level
—
74
38.
Advertisement
Table of Contents
