Removing An Ssd From An Nfx350 Series Device; Installing An Ssd In An Nfx350 Series Device - Juniper NFX350 Hardware Manual

Removing an SSD from an NFX350 Series Device

You need to power off the NFX350 Series device to remove an SSD from the device.
Ensure that you have the following equipment available:
Electrostatic discharge (ESD) grounding strap
An antistatic bag or an antistatic mat
SSD to replace
To remove an SSD, see (Figure 35 on page
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
2. Place the antistatic bag or the antistatic mat on a flat, stable surface.
3. Place your thumb on the SSD handle and press the tab below the SSD handle with one finger to unlock
the SSD from its slot.
4. Pull the SSD firmly to slide it out of its slot.
5. Place the SSD in the antistatic bag or on the antistatic mat placed on a flat, stable surface.
Figure 35: Removing an SSD

Installing an SSD in an NFX350 Series Device

You need to power off the NFX350 Series device to install an SSD into the device.
Ensure that you have the following equipment available:
112):
112