Table of Contents
Advertisement
connection. You define an interesting packet by using the dialer filter. To configure dial-on-demand by
using a dialer filter, you first configure the dialer filter and then apply the filter to the dialer interface.
Once the traffic is sent over the network, an inactivity timer is triggered and the connection is closed after
the timer expires.
NOTE:
The dial-on-demand mode is supported only if the LTE expansion module is configured
as a primary interface.
To configure the LTE expansion module as a dial-on-demand interface:
1. Configure the dialer interface:
user@host# set interfaces dl0 unit 0 family inet negotiate-address
user@host# set interfaces dl0 unit 0 family inet6 negotiate-address
user@host# set interfaces dl0 unit 0 family inet filter dialer dialer-filter-name
user@host# set interfaces dl0 unit 0 dialer-options pool dialer-pool-number
user@host# set interfaces dl0 unit 0 dialer-options dial-string dial-number
2. (Optional) Configure the idle-timeout value, which determines the duration for which the connection
will remain enabled in the absence of interesting traffic.
user@host# set interfaces dl0 unit 0 dialer-options idle-timeout idle-timeout-value
3. Configure the dialer pool for the LTE physical interface:
user@host# set interfaces cl-1/1/0 dialer-options pool dialer-pool-number
NOTE:
The dialer-pool-number is always 1 as there is only one LTE interface on the NFX350.
4. Create the dialer filter rule:
user@host# set firewall family inet dialer-filter dialer-filter-name term term1 from destination-address
ip-address then note
5. Set the default route:
set routing-options static route ip-address next-hop dl0.0
6. Configure the profile.
91
Advertisement
Table of Contents
