Management Port Connector Pinout Information For An Nfx350 Device - Juniper NFX350 Hardware Manual

CAUTION:
NFX350 device. Failure to do so could expose your device to unpredictable behavior.
NOTE: Executing the request system snapshot CLI command on a NFX350 device requires an
external USB flash drive with at least 4 GB of free space. We recommend using the RE-USB-4G-S
flash drive.
NOTE: USB flash drives used with the NFX350 device must support USB 2.0 or later.
SEE ALSO
NFX350 Chassis | 24

Management Port Connector Pinout Information for an NFX350 Device

The 1000BASE-T RJ-45 management port on an NFX350 device uses an RJ-45 connector to connect to
a management device for out-of-band management.
Table 29 on page 60 provides the pinout information of the RJ-45 management port connector.
Table 29: RJ-45 Management Port Connector Pinouts for the NFX350 Devices
Pin
1
2
3
4
5
6
Remove the USB flash drive before upgrading Junos OS or rebooting a
Signal
TRP1+
TRP1–
TRP2+
TRP3+
TRP3–
TRP2–
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
60