Table of Contents
Advertisement
To disconnect a fiber-optic cable from an optical transceiver installed in the NFX350 device:
1. (Recommended) Disable the port in which the transceiver is installed by including the disable statement
at the [edit interfaces] hierarchy level for the specific interface.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
WARNING:
instruments even if the interface has been disabled.
2. Carefully unplug the fiber-optic cable connector from the transceiver.
3. Cover the transceiver with a rubber safety cap.
WARNING:
or removing a cable. The rubber safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Cover the fiber-optic cable connector with the rubber safety cap.
SEE ALSO
Installing a Transceiver in an NFX350 Device | 101
Connecting a Fiber-Optic Cable to an NFX350 Device
You can connect fiber-optic cables to the field-replaceable unit (FRU) optical transceivers installed in
NFX350 devices.
Before you connect a fiber-optic cable to an optical transceiver installed in an NFX350 device, ensure that
you have taken the necessary precautions for safe handling of lasers (see
and Warnings for the NFX350 Devices" on page
Do not look directly into a fiber-optic transceiver or into the ends of
Do not stare into the laser beam or view it directly with optical
Do not leave a fiber-optic transceiver uncovered except when inserting
141).
"Laser and LED Safety Guidelines
106
Advertisement
Table of Contents
