Usb Port Specifications For An Nfx350 Device - Juniper NFX350 Hardware Manual

NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want to connect
your laptop or PC directly to an NFX350 device, use a combination of the RJ-45 cable and RJ-45
to DB-9 adapter supplied with the device and a USB to DB-9 male adapter. You must provide
the USB to DB-9 male adapter.
Table 28: Console Port Connector Pinouts for the NFX350 Device
Pin
1
2
3
4
5
6
7
8

USB Port Specifications for an NFX350 Device

The following Juniper Networks USB flash drive has been tested and is officially supported for the USB
port in the NFX350 devices:
RE-USB-4G-S—4-GB USB flash drive
CAUTION:
has not been tested by Juniper Networks. The use of any unsupported USB memory
product could expose your device to unpredictable behavior. Juniper Networks
Technical Assistance Center (JTAC) can provide only limited support for issues related
to unsupported hardware. We strongly recommend that you use only supported USB
flash drives.
Signal
RTS Output
DTR Output
TxD Output
Signal Ground
Signal Ground
RxD Input
DCD Input
CTS Input
Any USB memory product not listed as supported for the NFX350 device
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Clear to send
59