Removing An Nfx350 Device From A Rack Or Cabinet - Juniper NFX350 Hardware Manual

CAUTION:
system has halted. Please press any key to reboot. message. Wait for at least 60
seconds after seeing this message and before following the instructions in Steps 3
and 4 to power off the device.
CAUTION:
power supply.
3. Wrap and fasten one end of the ESD grounding strap around your wrist and connect the other end to
a site ESD point.
4. Set the power switch to OFF (O) position.
SEE ALSO
Connecting the NFX350 to Power | 71

Removing an NFX350 Device from a Rack or Cabinet

If you need to relocate an installed NFX350 device, use the procedure described in this topic. (The remainder
of this topic uses rack to mean rack or cabinet.)
NOTE: When you remove multiple devices from a rack, remove the device at the top of the rack
first and proceed to remove the rest of the devices from top to bottom.
CAUTION:
rack—one person to unscrew the mounting screws from the brackets and the second
person to hold the chassis.
Before removing the device from a rack:
The final output of any version of this command is the The operating
Ensure that you have halted your system safely before turning off the
At least two people must be available to lift a device chassis out of a
110