Enabling Basic Connectivity - Juniper NFX350 Hardware Manual

Table 35: Security Policies (continued)
Source Zone
trust
Table 36: Interfaces
Port Label Interface
0/0 to 0/7 ge-0/0/0 to ge-0/0/7
0/8 to 0/15 xe-0/0/8 to
xe-0/0/15
MGMT fxp0
The device is shipped with the following services enabled in the default security policy: DHCP, HTTP,
HTTPS, and SSH.
To provide secure traffic, a basic set of screens are configured on the untrust zone.

Enabling Basic Connectivity

1. Ensure that the device is powered on.
2. Connect to the console port:
a. Plug one end of the Ethernet cable into the console port on your device.
b. Connect the other end of the Ethernet cable to the RJ-45 to DB-9 serial port adapter shipped with
your device.
c. Connect the RJ-45 to DB-9 serial port adapter to the serial port on the management device. Use
the following values to configure the serial port:
Bits per second—9600; Parity—None; Data bits—8; Stop bits—1; Flow control—None.
Destination Zone
untrust
Security Zone
trust
trust
N/A
Policy Action
permit
DHCP State IP Address
server 192.168.2.1/24
client ISP assigned
N/A 192.168.1.1/24
84