Connecting The Ptx5000 Packet Transport Switch To A Management Console Or Auxiliary Device; Figure 39: Connecting To The Console Or Auxiliary Port On The Control Board; Connecting The Ptx5000 Packet Transport Switch To A Management Console Or; Auxiliary Device - Juniper PTX Series Hardware Manual

PTX5000 Packet Transport Switch Hardware Guide

Connecting the PTX5000 Packet Transport Switch to a Management Console or

Auxiliary Device

Related
Documentation
86
Attach one or more management console or auxiliary devices to the Routing Engine ports
on each control board for management and service operations (see
To connect the cables to a management console or auxiliary device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If necessary, turn off the power to the console or auxiliary device.
2.
Plug one end of a copper cable with RJ-45 connectors into the
3.
port on the control board in slot
into the control board in slot
Attach the other end of the cable to the console or auxiliary device.
4.
Plug one end of another copper cable with RJ-45 connectors into the
5.
port on
AUXILIARY CB1
control in slot .
CB1
Attach the other end of the cable to the console or auxiliary device.
6.
Figure 39: Connecting to the Console or Auxiliary Port on the Control
Board
1— Console port
PTX5000 Control Board Description on page 22
PTX5000 Management Interface Cable Specifications on page 271
RJ-45 Connector Pinouts for the PTX5000 AUXILIARY and CONSOLE Ports on page 272
CB0 . This port connects to the Routing Engine installed
.
CB0
. This port connects to the Routing Engine installed into the
1 2
2— Auxiliary port
Figure 39 on page
or
CONSOLE AUXILIARY
CONSOLE
Copyright © 2012, Juniper Networks, Inc.
86).
or