Maintaining The Nfx350 Ssd - Juniper NFX350 Hardware Manual

Ensure that the rack or cabinet is stable and secured to the building.
Ensure that there is enough space to place the removed device in its new location and along the path
to the new location.
Read "General Safety Guidelines and Warnings" on page
Guidelines for NFX350 Devices" on page
Ensure that the device has been safely powered off and that you have unplugged (disconnected) the
power cords.
Ensure that you have disconnected any cables or wires attached to the device.
Ensure that you have the following parts and tools available to remove the device:
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack mounting screws.
A labeled bag to hold the removed screws.
To remove an NFX350 device from a rack:
1. Use the appropriate Phillips (+) screwdriver to remove the mounting screws that attach the chassis
front-mounting brackets to the rack.
2. Place the removed screws in a labeled bag. You will need them when you reinstall the chassis.
3. Lift the chassis from the rack and carefully move the chassis to its new location.
SEE ALSO
General Safety Guidelines and Warnings | 124

Maintaining the NFX350 SSD

IN THIS SECTION
Removing an SSD from an NFX350 Series Device | 112
Installing an SSD in an NFX350 Series Device | 112
124, with particular attention to
131.
111
"Chassis Lifting