Programming the Agilent 16522A
MODe
MODe
The MODe command is used to specify either FULL or HALF channel output
mode. Half channel mode allows a higher output data rate (greater than 100
MHz), but with only 20 channels per card.
Full channel output mode limits the maximum data rate to 100 MHz but
allows use of 40 channels per card.
The output mode selection sets the upper limit for the clock rate (see
FORMat:CLOCk command).
Command syntax:
:FORMat:MODe{FULL|HALF}
Query syntax:
:FORMat:MODe?
Returned format:
[FORMat:MODe]{FULL|HALF}
Assigning labels in half-channel mode erases previously-assigned labels.
3–22