Table of Contents
Advertisement
SYSTem:DATA
The DATA command is used to send and receive the pattern generator main
program listings and the macro listings. The complete pattern generator data
block consists of two sections not counting the SYMBOL section. The
sections are:
Section 1 "DATA"
Section 2 "MACROS"
Command Syntax:
:SYSTem:DATA <block data>
Query Syntax:
:SYSTem:DATA?
Returned Format:
[:SYSTem:DATA] <block data><NL>
Section 1 "DATA"
The Main Program section contains the program listing data in binary form.
The length of this section depends on the length of the program listing and
the number of expansion cards connected to the master card.
Section 2 "MACROS"
The "MACROS" section contains all the program listing for all the macros.
The length of this section varies depending on the length of the macro
listings and the number of expansion cards connected to the master card.
To load data into the pattern generator in ASCII form, use the mainframe
command :MMEM:LOAD.
See Chapter 6 for information on creating ASCII files for the pattern generator.
Programming the Agilent 16522A
SYSTem:DATA
3–57
Advertisement
Table of Contents
