Table of Contents
Advertisement
When deleting vector rows, the INIT START, INIT END, MAIN START, and
MAIN END cannot be deleted. Deleting all the vector rows from INIT START
to MAIN END will reset the sequence to the power up state. The delete will
not be performed if the results of the delete will place fewer than two vectors
in the main sequence, or, if the delete will place an instruction on any of the
following vectors:
•
The first vector of the INIT sequence.
•
The first vector of the MAIN sequence.
•
The last vector of the MAIN sequence.
•
The vector prior to the IF block.
•
The first vector of the IF block.
•
The last vector of the IF block.
•
The vector following the IF block.
Merge
Touching the Merge field brings up a pop-up menu that lets you select
sections of a previously created configuration file to merge after the current
line in the sequence. The Input Drive field selects between the hard disk or
the front floppy disk (if present). The Filename field displays a file browser
pop-up menu that allows searching for the file to be used in the merge. The
Merge Section field allows selection of the section of the configuration to be
merged. Configuration sections are the main sequence and any macros that
were created. The merge will not be performed in the following cases:
•
Merge data exceeds the maximum number of sequence lines.
•
Merge data requires more repeats than are available.
•
Merge data requires more macro calls than are available.
Agilent Technologies 16522A Reference
The Sequence Menu
2–9
Advertisement
Table of Contents
