Table of Contents
Advertisement
Installation
To configure a multi-card module
On the expander card, disconnect the end of the 2x10 cable that is
2
plugged into the connector labeled "Master Output."
C A U T I O N
If you pull on the flexible ribbon part of the 2x10 cable, you might damage
the cable assembly.
Using your thumb and finger, grasp the ends of the cable connector.
Apply pressure to the ends of the cable connector to disengage the
metal locking tabs of the connector from the cable socket on the
board. Then, pull the connector from the cable socket.
5–7
Advertisement
Table of Contents
