Table of Contents
Advertisement
inserting lines as needed. The repeat loop is assigned a loop number by the
system and is used to connect the limits of the repeat loop.
Note that there are location restrictions on the use of the REPeat instruction.
MACRo# The MACRo# instruction is used to invoke a previously
defined user macro. The macro number is part of the instruction string
(not the optional instruction argument parameter). If the macro has
been defined to use passed-in parameters, those parameter values are
passed in via the data value fields. If no parameters are defined, a single
dummy parameter must be used ('0'). There is otherwise no data
associated with a macro instruction.
Command Syntax
:SEQuence:INSert <line_number>,{NOOP|IF,<event>|
WAIT,<event>|SIGNal|REPeat,<count>|BREAK|
MACRo<#>},<data_value>,<data_value>,...
integer where instruction/data will be inserted after
<line_number>
{ A | B | C | D | IF | IMB }
<event>
integer repeat count
<count>
macro number
<#>
a string in one of the following forms:
<data_value>
'#B01...' for binary
'#Q01234567...' for octal
'#H0123456789ABCDEF...' for hexadecimal
'0123456789...' for decimal
Example
10 OUTPUT XXX; " :SEQ: INS 248, NOOP, '17', '34', '121'"
20 OUTPUT XXX; " :SEQ: INS 1786, WAIT, A,'17', '34', '121'"
30 OUTPUT XXX; " :SEQ: INS 2652, REPEAT, 26, '17', '34', '121'"
40 OUTPUT XXX; " :SEQ: INS 3166, MACR4, '#HABCD'"
41 !Passes a single parameter to this instance of MACRO #4.
50 OUTPUT XXX; " :SEQ: INS 3186, MACR6, '0'"
51 !Assume no parameter defined for MACRO 6.
Programming the Agilent 16522A
INSert
3–31
Advertisement
Table of Contents
