Table of Contents
Advertisement
9.2.1. Troubleshooting Call tracing
Call tracing on the Avaya Communication Server (CS1000E) can be carried via the CLI.
To trace the activity of an endpoint, enter the following:
Command
>LD 80
.entc <TN> hhmm
.GOTR
.STPT
To monitor the activity on the E1 Link to Dialogic IMG 1010, messaging must be enabled on the
relevant D-Channel and then output can be display to the monitor screen.
Command
>LD 96
.enl msgi X
(where X is the D-Channel)
.enl msgo X
(where X is the D-Channel)
.enl mon tty
.dis mon tty
BD; Reviewed:
SPOC 02/26/2013
Solution & Interoperability Test Lab Application Notes
©2013 Avaya Inc. All Rights Reserved.
Comment
Use load 80 for tracing. enter
i.e. .entc 96 0 0 1 0010. The TN is the TN
number of the endpoint and 0010 will run the
trace for 10 minutes. GOTR will start the trace.
The trace will stop after 10 minutes else type
STPT to stop the trace manually.
Comment
Use load 96 for tracing on the D-Channels
Enable Incoming messages on DCH X
Enable Outgoing messages on DCH X
To display the traffic on the screen of the
PuTTY session
To stop the display of traffic on the PuTTY
screen
92 of 103
DLG1010MXSM62CS
Advertisement
Table of Contents
