Chapter 6: Completing the installation
This section covers the following tasks:
Verifying translations
●
Setting daylight savings time rules
●
Setting locations (if necessary)
●
Verifying date and time
●
Resolving alarms
●
Enabling and disabling Ethernet switch ports
●
Backing up files to the compact flash media (S8710 only)
●
Backing up files to the PCMCIA flashcard (S8700 only)
●
Telneting to media server
●
Enabling alarms
●
Registering the system
●
Verifying translations
These steps verify translations.
1. Type list configuration all and press Enter to view all the administered circuit
packs in the system.
2. Type list ipsi and press Enter to verify the location of the IPSI circuit packs.
3. Check the administration status on the following items:
list station
●
list trunk-group
●
list hunt-group
●
Note:
Even though you set the date, time, and time zone through the Web interface on
Note:
the media server, you also must set the daylight savings time rules and locations
and verify the date and time through SAT commands.
administration
on page 71
on page 74
on page 74
on page 79
on page 79
on page 80
on page 72
on page 73
on page 75
on page 77
on page 78
Issue 4.1 June 2005
71