Avaya S8500 Manual page 110

Postmigration administration
Figure 21: Connecting directly to the IPSI
cadlipsi KLC 031502
Figure notes
1 Services laptop
2 PCMCIA Network Interface Card (NIC)
1
Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.
2
From the services laptop Start Menu, click Start > Run to open the Run dialog box.
3
Type
command
4
Type
arp -d 192.11.13.6
responds with one of the following:
•
•
5
Type telnet 192.11.13.6
Prompt = [IPSI]:
110
1
NOTE:
Make sure you have the password before proceeding.
and press Enter to open a MS-DOS Command Line window.
and press
The command line prompt when the cache has been cleared.
The phrase: The specified entry was not found. This is returned when the specified IP
address does not currently contain an entry in the ARP cache.
and press Enter to open the Telnet window and connect to the IPSI
NOTE:
While connected to the IPSI, type
two or three letter abbreviations.
2
3
3 NIC adapter cable (if necessary)
4 CAT5 crossover cable to IPSI
to clear the ARP cache in the laptop. This command
Enter
or to obtain online help. Most commands have
help ?
Migrating to the Avaya S8700 or S8710 Media Server
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
4
June 2004