Converting A Processor Port Network To A Port Network (Ip600); Verifying Hardware - Avaya S8500 Manual

Converting a processor port network to a port network (IP600)

Converting a processor port network to a port network
(IP600)
There is no supported method for moving translations from the existing systems to the S8700 IP Connect
configuration. Everything must be retranslated.
This section covers the following tasks:
•
Verifying hardware
•
Converting the IP600 control chassis to a port network
•
Powering down the control chassis
•
Replacing the WP cables
•
Replacing the processor circuit pack
•
Replacing the TN799C C-LAN circuit pack (if necessary)
•
Connecting to the media server
•
Postmigration administration

Verifying hardware

Make sure you have the conversion specific hardware on hand. See
Hardware, on page 102 for a list of required hardware.
Table 12: Required Migration Hardware 1 of 2
Comcode
700260359
700263502
700276389
700170012
700178056
700178064
700060643
700055015
102
NOTE:
This section applies to the S8700 IP-Connect configuration only.
NOTE:
If you want to make the system high reliability, then you cannot reuse the IP600 cabinets.
You must install Avaya G650 Media Gateways and move all the circuit packs to the G650.
NOTE:
This section applies only to the S8700 or S8710 IP-Connect configuration.
on page 102
on page 104
on page 106
on page 107
Description
TN2312BP IP Server Interface circuit pack
IPSI adapter
Maintenance cable (attaches to IPSI adapter-optional)
Green CAT5 Ethernet cable:
- 5-meter (16 feet)
- 25-meter (82 feet)
- 50-meter (164 feet)
TN2302AP IP Media Processor circuit pack
TN799DP C-LAN circuit pack (to replace TN799C)
on page 103
on page 104
on page 106
on page 106
Table 12, Required Migration
Migrating to the Avaya S8700 or S8710 Media Server
Quantity
1
1
1
1
1
1
1 or more
1 or more
June 2004