Replacing The Processor Circuit Pack; Replacing The Tn799C C-Lan Circuit Pack (If Necessary); Adding Tn2302Ap Ip Media Processor; Installing Tn771 Maintenance/Test - Avaya S8500 Manual

Converting a processor port network to a port network (IP600)

Replacing the processor circuit pack

1
Remove the entire processor circuit pack and place it in an antistatic carrier or bag. You want it
intact if you need to back out of the migration.
2
Remove the octopus cable from the connector associated with slot 2 on the backplane.
3
Install the IPSI adapter to the connector associated with slot 2 on the backplane.
4
Install the maintenance cable onto the 9-pin D-sub connector on the Adapter. This cable is for
emergency transfer and "auxsig" signal.
5
Insert the TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack into slot 2.
6
Attach the new label above the circuit pack slots.
Replacing the TN799C C-LAN circuit pack (if
necessary)
1
Remove the TN799C C-LAN circuit pack and place it in an antistatic carrier or bag.
2
Insert the new TN799DP C-LAN circuit pack into the same slot.
3
Replace the 259A adapter and CAT3 cable on the backplane with the Amphenol adapter used for
the TN2302AP IP Media Processor circuit pack and a CAT5 cable.

Adding TN2302AP IP Media Processor

Installing TN771 Maintenance/Test

Install a TN771 Maintenance/Test circuit pack in slot 1. There must be one TN771 Maintenance/Test
circuit pack per location. Maintenance functions were present on the TN798 or TN2402 Processor circuit
pack and must be replaced by the TN771. This carrier does not have a TN775 Maintenance (EPN)
dedicated slot.

Connecting to the media server

Connect one end of the GREEN CAT5 straight-through cable to the Ethernet switch on the customer's
network and the other to the IPSI adapter on the back of the media gateway.
106
NOTE:
The TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack takes up only one
slot.
Migrating to the Avaya S8700 or S8710 Media Server
June 2004