Avaya S8500 Manual page 62

Upgrading and administering the existing hardware
16
Assign the Switch and Cabinet ID to the TN2312BP Internet Protocol Server Interface (IPSI-2)
just inserted. See
17
Type
set tone cabinet carrier
18
Type status port-network number
Enter to verify that the tone-clock moved to the other carrier. Verify that the YELLOW LED on
the IPSI circuit pack is flashing.
19
Remove the TN2182 Tone Clock circuit pack from the new standby carrier (B) and place in an
antistatic carrier.
20
Insert the TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack part way into the
TONE-CLOCK slot on the standby carrier (B).
21
With the red line on the bottom (pin 1), attach one end of the long ribbon cable to the connector on
the component side of the circuit pack.
22
Push the tabs on the ends of the connector inward to lock the connector in place. See
Ribbon Cable Connector,
23
Thread the ribbon through the slot on the front panel.
24
Attach the other end of the long ribbon cable to the bottom connector on the component side of
the TN775D Maintenance (EPN) circuit pack (red line on the bottom). See
Reliability Ribbon Cable Connection,
25
Fully insert the TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack.
26
Program the TN2312BP Internet Protocol Server Interface (IPSI-2) just inserted. See
IP addresses to the IPSI circuit packs
27
Fully insert the TN775D Maintenance (EPN) circuit pack after both IPSIs have been
programmed.
62
Assigning IP addresses to the IPSI circuit packs
and press
Enter
where number is the number of the port network and press
on page 59.
on page 63.
on page 107.
Migrating to the Avaya S8700 or S8710 Media Server
on page 107.
to force a tone-clock interchange.
Figure 4,
Figure 6, High/Critical
Assigning
June 2004