Configure Lan Properties - Polycom RealPresence Group Series Administrator's Manual

Indicator Light
Left light green
Right light off
Right light on
Right light blinking

Configure LAN Properties

You can configure LAN properties for your system in the local interface or the system web interface.
Procedure
1. In the system web interface, go to Admin Settings > Network > LAN Properties.
2. Configure the following LAN Options settings in the system web interface at Admin Settings >
Network > LAN Properties > LAN Options.
Setting
Host Name
(system web interface only)
Domain Name
(system web interface only)
Polycom, Inc.
Connection Status
1000Base-T connection.
No 10/100 Base-T connection and no network traffic
with 1000 Base-T connection.
10/100 Base-T connection and blinks with network
traffic.
Network traffic.
Description
Indicates your system name. If the system discovers a
valid name during setup or a software update, the
system automatically creates the hostname. However,
if an invalid name is found, such as a name with a
space, the system creates a hostname using the
following format: SystemType-xxxxxx, where
xxxxxx is a set of random alphanumeric characters.
IPv4 networks: The system sends the host name to
the DHCP server to attempt to register the name with
the local DNS server or look up the domain where the
system is registered (if supported).
IPv6 networks: You can leave this field blank since the
system doesn't support this function. However,
Polycom recommends configuring the field to contain
the registered host name.
Identifies the domain your system belongs to.
If the system doesn't automatically obtain a domain
name, optionally enter one here.
Configuring Network Settings
58