Adjust The Room View; Calibrate The Eagleeye Director Cameras - Polycom RealPresence Group Series Administrator's Manual

Indicator Light
Steady green light
Steady red light
Blinking red light
Blinking blue light

Adjust the Room View

You can adjust the room view on the EagleEye Director to get the best perspective for your video calls.
Procedure
1. Do one of the following:
• From the local interface, go to
Calibration, and then select Begin Calibration.
• From the system web interface, go to Admin Settings > Audio/Video > Video Inputs, and
then select the Input used by the EagleEye Director.
2. Do one of the following:
• In the local interface, select Skip to move to the Adjust Room View screen.
• In the system web interface, select Adjust Room View.
3. Use the arrow buttons and zoom controls on the remote control or system web interface to show
the room view you want far site participants to see.
4. Select Finish to save the settings and return to the Camera Settings screen.

Calibrate the EagleEye Director Cameras

In Voice Tracking mode, you only need to calibrate the right camera. In Direct Cut mode, calibrate the
right camera and then left one. Ensure that only one person speaks while you are calibrating the cameras
and keep the background quiet. If you rearrange or move the EagleEye Director, recalibrate it.
Procedure
1. Do one of the following:
• In the local interface, go to
Calibration.
• In the system web interface, go to Admin Settings > Audio/Video > Video Inputs and
select Calibrate Voice Tracking.
2. Follow the directions in the Auto Calibration screen that appears.
When you click Start, auto-calibration begins. When the automatic process ends, you have these
choices:
• Yes, I see a green box around my mouth. Selecting this choice means auto-calibration
was successful and you can move forward with adjusting the room view, if you like.
• No, I see a green box, but it is not around my mouth. Selecting this choice means you
can try auto-calibration again or manually calibrate the camera.
Polycom, Inc.
Configuring a Camera or Camera Control System
System Status
Cameras are ready; camera tracking is off
Cameras are powering on
Factory restore on the cameras is starting
Camera tracking is on
> Settings > Administration > Camera Tracking >
> Settings > Administration > Camera Tracking >
186