Polycom RealPresence Group Series Administrator's Manual page 225

Settings
DNS Servers
VLAN
LAN Speed
Duplex Mode
Enable EAP/802.1X
(under EAP 802.1X in the system local interface)
EAP/802.1X Identity
(under EAP 802.1X in local interface)
EAP/802.1X Password
(under EAP 802.1X in local interface)
Polycom, Inc.
Setting Up a Polycom RealPresence Touch Device
Description
Displays the DNS servers assigned to the device. You
can specify IPv4 DNS server addresses only when the
IPv4 address is entered manually. When the IPv4
address is obtained automatically, the DNS server
addresses are also obtained automatically.
• Server 1: If the RealPresence Touch device does
not automatically obtain a DNS server address, add
a DNS server address here.
• Server 2: If the RealPresence Touch device does
not automatically obtain a DNS server address, add
a DNS server address here.
Specifies the identification of the Virtual LAN. This
setting is available only when 802.1p/Q is enabled. The
value can be any number from 1 to 4094.
Specifies whether to use 10 Mbps, 100 Mbps, or 1000
Mbps for the LAN speed. If the Autonegotiation
setting is enabled, this setting is read-only. To change
the Autonegotiation setting, in the RealPresence
Group Series system web interface, go to Admin
Settings > Network > LAN Properties > LAN
OptionsSelect or clear the Autonegotiation checkbox.
Choose the Duplex mode that is supported by the
switch, either Full or Half. If the Autonegotiation
setting is enabled, this setting is read-only. To change
the Autonegotiation setting, use the RealPresence
Group Series system web interface, and go to Admin
Settings > Network > LAN Properties > LAN
Options Select or clear the Autonegotiation
checkbox.
Specifies whether EAP/802.1X network access is
enabled. The following authentication protocols are
supported:
• EAP-MD5
• EAP-PEAPv0 (MSCHAPv2)
• EAP-TTLS
• EAP-TLS
Specifies the system's identity used for 802.1X
authentication. This setting is available only when EAP/
802.1X is enabled. The field cannot be blank
Specifies the system's password used for 802.1X
authentication. This setting is required when EAP-MD5,
EAP-PEAPv0, or EAP-TTLS is used.
223