Enabling Content Sharing; Configure Content Sharing - Polycom RealPresence Group Series Administrator's Manual

Enabling Content Sharing

Topics:
•

Configure Content Sharing

• Adjust Audio Level for Content
• Connecting a Computer
• Configure Monitor 1 as the Content Monitor
• Configure Monitor 2 as the Content Monitor
• Setting Up a Polycom Content Display Application
• Closed Captioning
• Enable VisualBoard Content Sharing
• Prerequisites for the VisualBoard Application
• Configure the Polycom UC Board
• Sharing Content During Calls
• Configuring DVD Player Settings
Configure Content Sharing
You can configure content sharing in the RealPresence Group Series system web interface. For content
to display properly, the system's Monitor 2 must support Progressive mode, and the output resolution
should be set to a Progressive setting, such as 1280x720p or 1920x1080p. Interlaced output for Monitor 2
is not supported. Do not use the resolution setting 1920x1080i.
Procedure
1. In the system web interface, go to Admin Settings > Audio/Video > Video Inputs and select the
input you want to configure for content.
2. For the Display as setting, select Content for the input that will display content.
When you connect a content-sharing device such as a laptop to the input, the content starts
displaying. If the content-sharing device is already connected, you must manually show the
content from the local interface. For more information about sharing content, refer to the Polycom
RealPresence Group Series User Guide .
If default values for other settings in the system have not changed, you are ready to share content
on your system. However, if you disabled the H.239 protocol, you must enable the program for
content sharing by following these steps:
3. In the system web interface, go to Admin Settings > Network > Dialing Preference.
4. Enable H.239.
Note: While in a call, you cannot enable or disable H.239.
Polycom, Inc. 199