Polycom RealPresence Group Series Administrator's Manual page 159

Procedure
1. In the system web interface, go to Admin Settings > Audio/Video > Video Inputs.
2. Configure the following settings and select Save.
Setting
Model
Name
Display as
Input format
Optimized for
Tracking Mode (Polycom EagleEye Director
Camera)
Tracking Speed (Polycom EagleEye
Director Camera)
Polycom, Inc.
Description
Displays the type of device connected to the system.
Displays the default name of the connected device. You also can
enter a name for the device.
Identifies whether the video input is used for People or Content.
The selection you make here determines the available settings for
the device in the embedded interface. For example, a People
source has pan, tilt, zoom, and near/far camera control settings,
while a Content source doesn't.
Specifies the source type of the device. This setting is read-only
unless the system doesn't detect the device.
Specifies optimization preferences for the video input.
• Motion: Gives preference to frames per second over
resolution. For the connected source, the system selects
720p60 over 1080p30.
• Sharpness: Gives preference to resolution over frames per
second. For the connected source, the system selects 1080p30
over 720p60. With this setting, moderate-to-heavy motion at
low call rates can cause some frames to drop. Sharpness is
available in point-to-point H.263 and H.264 calls only. It is
required for HD calls between 512 Kbps and 2 Mbps.
Specifies the type of camera tracking:
• Voice—Locates and frames the speaker. When another
speaker starts talking, the view switches from the first speaker
to the room, then to the next speaker.
• Direct Cut—Tracks directly from speaker to speaker if silence
intervals are less than 3 seconds. You must recalibrate the left
camera when you select Direct Cut mode.
If camera tracking has not been calibrated, Tracking Mode is
unavailable.
Note: Only available when you have installed an EagleEye
Director camera.
Determines how quickly the camera finds and switches to the new
speaker. The room environment can influence how fast the camera
locates new speakers.
Note: Only available when you have installed an EagleEye
Director camera.
Configuring Video Settings
157