Recharge The Remote Control Battery - Polycom RealPresence Group Series Administrator's Manual

Otherwise, the LED flashes six times and allows you to repeat step 3.

Recharge the Remote Control Battery

Your system setup sheet shows how to charge the battery in the remote control the first time. When the
remote control battery power is at 10% or less, a notification is displayed on the home screen. The low
battery notification returns after you dismiss other notifications, and is not displayed while the system is in
a call.
Procedure
1. Pull the battery out of the end of the remote control.
2. Insert the USB plug into any USB 2.0 port, such as the one on your system.
The RealPresence Group 300, RealPresence Group 310, and RealPresence Group 500 systems
have two USB 2.0 ports on the back of the systems, while the RealPresence Group 700 system
has one USB 2.0 port on the front.
3. Insert the USB plug into any USB 2.0 port, such as the one on your system.
4. While the battery is charging, the status light is orange.
After the status light on the battery turns green, remove it from the port.
5. Insert the charged battery into the remote control.
Note: Recharging the battery might take anywhere from 20 minutes to several hours.
The following figure illustrates these steps for the RealPresence Group 300, RealPresence Group 310,
RealPresence Group 500, and RealPresence Group 700 systems.
Polycom, Inc.
Configuring Remote Control Behavior
195