Left Edge Margin Adjustment (2Nd Side) - Canon imageRUNNER ADVANCE 8105 Series Service Manual

5) Open the MP Pickup Tray.
6) Loosen the screw and adjust the position of the Slide Guide by referring to the scale.
•
In the case of larger margin at the rear side, move the Slide Guide to the front side.
•
In the case of larger margin at the front side, move the Slide Guide to the rear side.
Scale
7) Tighten the screw loosened in step 6).
8) Print from the Multi-purpose Tray Pickup, and check that the left edge margin of the image
is within 2.5 +/- 1.5mm.
MEMO:
When a mechanical adjustment was made, be sure to execute the service mode in step
1) again.
9
Installation > Installation > Image Position Adjustment > Left Edge Margin Adjustment (2nd side)
■

Left Edge Margin Adjustment (2nd side)

MEMO:
By executing the margin adjustment (2nd side) for the Cassette 3, the adjustment is
applied to all source of paper.
Execute duplex printing from the Cassette 3, and check that the left edge margin is within 2.5
+/- 2.0mm.
If it is not within the range, execute adjustment by following the procedure below.
Slide Guide
1) Adjust the image position in service mode.
F-9-79 F-9-79
•
COPIER > ADJUST > FEED-ADJ > ADJ-REFE
As the value is incremented by 1, the left edge margin is increased by 0.1mm.
2) Execute duplex printing from the Cassette 3, and check that the left edge margin is within 2.5
+/- 2.0mm.
3) W hen the setting value was changed in step 1), write down the new numerical value in the
service label.
4) Exit from the service mode.
9 Installation > Installation > Image Position Adjustment > Left Edge Margin Adjustment (2nd side)
Feeding direction
of paper
image
F-9-80 F-9-80
9-36
9-36