6) Connect the STS Cable (340mm (Light Blue); FM3-9152) to the Main Controller PCB 2 and
the Encryption Board.
•
2 Connectors
•
1 Edge Saddle
•
5 Wire Saddles
CAUTION:
Check that the STS Cable is connected properly at the time of installation because the
machine can operate even the cable is not connected.
x2
Connector
x6
9
Installation > HDD Data Encryption & Mirroring Kit-C2 > In the Case of Fixed HDD > Installing the Encryption Board
7) Install the LED Board to the back side of the HDD Case Unit.
•
2 Screws (TP; M3x6)
Connector
F-9-645
9
Installation > HDD Data Encryption & Mirroring Kit-C2 > In the Case of Fixed HDD > Installing the Encryption Board
9-320
x2
F-9-646
9-320