Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1265

10) Remove the HDD Case Unit.
• 2 Screws (The removed screws will be used in "Installing the Encryption Board and HDD
Case Unit" step 3).)
x2
■ Changing Configuration inside of HDD Case Unit
1) Remove the E-ring from the removed HDD Case Unit, remove the shaft of the HDD Cap,
and then remove the HDD Fixed Plate. (The removed HDD Fixed Plate will not be used.)
9
Installation > [TYPE-11] Option HDD (250GB) + Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Changing C
2) Put the HDD Cap and the shaft back to the HDD Case Unit, and secure the HDD Case Unit
with the E-ring.
3) Remove the Upper Rail from the HDD Case Unit.
•
2 Screws (The removed screws will be used in step 6).)
F-9-602
4) Remove the Leaf Spring from the removed rail in the order of the arrows in the figure
below. (The removed Leaf Spring will not be used.)
• 2 Bosses
•
2 Arms
Boss
F-9-603
9 Installation > [TYPE-11] Option HDD (250GB) + Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Changing C
x2
Boss
Turn over
9-303
F-9-604
Arm
F-9-605
9-303