Checking after Installation
MEMO:
Execute the procedure to enable the mirroring function.
1) Connect the power plug to the outlet.
2) Turn ON the main power switch.
3) Specify the setting for mirroring.
•
Service Mode > COPIER > OPTION > FNC-SW > W/RAID; select "1" for W/RAID
4) Turn OFF/ON the main power switch to enable the setting value.
5) Check that the UI screen is started normally.
6) Open the HDD Cover, and check that the LED is flashing.
The green LED of HDD1 (Slot1) is flashing.
•
The green and red LEDs of HDD2 (Slot2) are flashing.
•
9
Installation > HDD Data Encryption & Mirroring Kit-C2 > Checking after Installation
F-9-664
9
Installation > HDD Data Encryption & Mirroring Kit-C2 > Checking after Installation
9-328
9-328