Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1286

< In the Case of a single HDD>
12) Put the Signal Cable and the Power Supply Cable through [A] part.
13) Connect the 2 connectors of the Signal Cables and the Power Supply Cables to the
Encryption Board.
CAUTION:
When connecting the Signal Cables, the side labeled "ch.A" should be connected to on
the Encryption Board.
[A]
x2
9
Installation > HDD Data Encryption & Mirroring Kit-C2 > In the Case of Fixed HDD > Installing the Encryption Board
Power Supply Cable Signal Cable
(570mm; FK2-7831) (550mm; FK2-7826)
CH A
F-9-656
9
Installation > HDD Data Encryption & Mirroring Kit-C2 > In the Case of Fixed HDD > Installing the Encryption Board
< In the Case of 2 HDDs>
14) Secure the Signal Cable and the Power Supply Cable.
•
9 Wire Saddles
•
1 Edger Saddle
CAUTION:
•
Secure the cables so that there is no extra slack of the cables at [A] part.
•
Be sure that the Wire Saddle [B] is properly securing the cables.
[A]
x10
9-324
[B]
F-9-657
9-324