Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1303

8) Connect the LED Cable (310mm; FM3-9158) to the LED Board and the Encryption Board.
• 2 Connectors
•
7 Wire Saddles
CAUTION:
Check that the STS Cable is connected properly at the time of installation because the
machine can operate even the cable is not connected.
x2
x6
9
Installation > HDD Data Encryption & Mirroring Kit-C2 + Removable HDD Kit > In the Case of the Removable HDD > Installing the Encryption Bo
9) Close the Wire Saddle.
10) Connect the 4 Connectors of the Signal Cables and the Power Supply Cables to the
Encryption Board.
•
Power Supply Cable (HDD2)
•
Signal Cable (Blue)
• Signal Cable (Red)
•
Power Supply Cable (HDD1)
F-9-697
9
Installation > HDD Data Encryption & Mirroring Kit-C2 + Removable HDD Kit > In the Case of the Removable HDD > Installing the Encryption Bo
Power Supply Cable (CH B)
x4
CH B
CH A
Power Supply Cable (CH A)
9-341
F-9-698
Signal Cable (CH B)
Signal Cable (CH A)
F-9-699
9-341