Adjusting Margin Of Multi-Purpose Pickup Tray - Canon imageRUNNER ADVANCE 8105 Series Service Manual

MEMO:
If you concern alignment of the Cassette Front Cover, adjust the left and right sides of
the cover as necessary.
Loosen the 4 screws and adjust the position of the Cassette Front Cover by referring
10)
to the scale.
When moving the Cassette Button Link Unit, adjust the left side of the Cassette Front
11)
Cover by shifting it with the same shifting amount of the unit.
Cassette Front Cover
Scale
Once the position of the Cassette Front Cover is confirmed, tighten the 4 screws
12)
(which have been loosened in step 10)).
13) Print from the cassette/deck, and check that the left edge margin of the image is
within 2.5 +/- 1.5mm.
MEMO:
When a mechanical adjustment was made, be sure to execute the service mode in step
1) again.
9
Installation > Installation > Image Position Adjustment > Adjusting margin of Multi-purpose Pickup Tray
Cassette Front Cover
Scale
Cassette Front Cover
F-9-77 F-9-77
9 Installation > Installation > Image Position Adjustment > Adjusting margin of Multi-purpose Pickup Tray
■

Adjusting margin of Multi-purpose Pickup Tray

Print from the Multi-purpose Tray Pickup, and check that the left edge margin of the image is
within 2.5 +/- 1.5mm.
If it is not within the range, execute adjustment by following the procedure below.
Feeding direction
of paper
1) Adjust the image position in service mode.
•
COPIER > ADJUST > FEED-ADJ > ADJ-MF
MEMO:
<Setting Range>
-20 to 20 (0.1mm per unit)
As the value is incremented by 1, the left edge margin is increased by 0.1mm.
2) When the setting value was changed in step 1), write down the new numerical value in the
service label.
3) Exit from the service mode.
4) P rint from the Multi-purpose Tray Pickup, and check that the left edge margin of the image
is within 2.5 +/- 1.5mm.
MEMO:
If the adjustment cannot be made with the setting value of -20 to 20 (adjustment
amount: -2.0 to 2.0mm), execute step 5) and later steps.
9-35
image
F-9-78 F-9-78
9-35