Checking The Network Connection; Operation Procedure Using Ping; Checking By The Remote Host Address - Canon imageRUNNER ADVANCE 8105 Series Service Manual

Checking the Network Connection

■
Overview
If the user's network environment is TCP/IP, use the Ping function to check that the network
setting is properly performed.
If the user's network environment is IPX/SPX or Apple Talk, there is no need to check the
network environment.
■
Checking the Network Connection
CAUTION:
Be sure to use the network cable with Category 5e or higher. In addition, a sealed type
(STP cable) is recommended.
Using the non-shield type can affect the peripheral electrical equipment through the
network cable.
1) Turn OFF the main power switch.
2) Connect the network cable to the Host Machine and turn ON the main power switch.
3) Inform the system administrator at the installation site that installation of the Host Machine
is complete, and then, ask for the network setting.
MEMO:
Network setting cannot be executed unless logging in as an administrator.
Factory default password is as follows.
• System administration division ID: 7654321
•
System administration password: 7654321
CAUTION:
To perform the network setting, the following Additional Functions items must be set
"ON".
[Additional Functions] > [Configuration] > [Network] > [Change network settings/
•
check connection]
[Additional Functions] > [Configuration] > [Network] > [TCP/IP Setting] > [IPv4
•
setting] > [Use IPv4]
4) Turn OFF and then ON the main power.
9
Installation > Installation > Checking the Network Connection > Checking by the Remote Host Address
■

Operation Procedure Using Ping

CAUTION:
To execute Ping command with the Windows Vista-installed PC, set OFF the firewall, or
execute Ping command from the Windows Vista-installed PC to the Host Machine.
1) Select the following: [Additional Functions] > [Configuration] > [Network] > [TCP/IP setting]
> [IPv4 setting] > [PING command]
2) Enter the IP address with the numeric keypad on the Control Panel and press "Execute"
key. "Response from the host" is displayed if Ping command is succeeded while "no
response from the host" is displayed if failed.
■

Checking by the Remote Host Address

Using the remote host address to execute Ping can check whether connection to the network
is enabled or not.
Remote host address: IP address of PC terminal connected/running on TCP/IP network
environment that connects to this equipment.
1) Inform the system administrator about checking of the network connection using Ping.
2) Confirm the remote host address with the system administrator.
3) Enter the remote host address to Ping.
• The network is properly connected if the message say "Response from the host".
•
The network is not properly connected if the message say "No response from the host",
therefore, execute the following troubleshooting.
9
Installation > Installation > Checking the Network Connection > Checking by the Remote Host Address
9-38
9-38