Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1076

3) Install the Conversion Connector.
CAUTION:
Be sure that there is no gap between the HDD Connector and the Conversion
Connector.
9
Installation > [TYPE-2] Removable HDD Kit > Installation Procedure > Disassembling and Assembling of the HDD Removed from the Host Machin
4) Fit the 2 bosses of the Connector Fixation Screw into the holes of the Conversion
Connector to install, and tighten the screws in the order specified below.
•
2 Screws (P Tightening; M3x8)
CAUTION:
•
•
F-9-253 F-9-253
9
Installation > [TYPE-2] Removable HDD Kit > Installation Procedure > Disassembling and Assembling of the HDD Removed from the Host Machin
Be sure to firmly hold the Connector Fixation Block when tightening the screws.
Be sure to follow the correct order to tighten the screws, otherwise the Conversion
Connector may not be connected properly, resulting in poor contact.
x2
9-114
F-9-254 F-9-254
Boss
Hole
F-9-255 F-9-255
9-114