Siemens SIMATIC PCS 7 Function Manual page 187

QJOBSTAT
Bit 23
Bit 25
Bit 26
Bit 27
Bit 28
Bit 29
"QMSG" status word
QMSG
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 8
Bit 9
Bit 10
Feedback monitoring of the control commands
Control command feedback monitoring is activated by setting bit "10" of the "MODE" input (bit
10 = 1). The monitoring time is specified at the "TIME_MON" input. The following monitoring
options have been implemented:
● "START" and no "JOB_ON" feedback
● No "START" and "JOB_ON" or "RUN" or "HELD" feedback
● "RESUME" and no "RUN" feedback
● "HOLD" and no "HELD" feedback
A fault message is sent when the monitoring time has elapsed.
Status tracking
Status tracking can be activated with "MODE" bit 11 = 1 and is executed in the "JOB_ON" =
1 state.
● Tracking to "HOLD"
Following a positive edge at the input "SFC_HELD" or "FB_HELD" and "SFC_RESUME"
or "QRUN" = 1
● Tracking to "RESUME"
Following a positive edge at the input "SFC_RUN" or "FB_RUN" and "SFC_HOLD" or
"QHOLD" = 1
Advanced Process Functions (APF)
Function Manual, 07/2016, A5E38719883-AA
Symbol
JOB_ACTIV
START
HOLD
RESUM
GO_END
ABORTION
Symbol
START
HOLD
RESUM
GOEND
ABORT
NEW
DEL
ACTIVE
1 = Job running (not paused)
1 = Job "start
1 = Job "hold"
1 = Job "resume"
1 = Job "end"
1 = Job "abort"
1 = Job start message
1 = Job hold message
1 = Job resume message
1 = Job end message
1 = Job abort message
1 = Create job message
1 = Delete job message
1 = Activate job message
Order management
7.1 FB_JOB
Meaning
Meaning
187