Lights/Meters/Switches - Honda Hawk GT NT650 1988 Service Manual

18. LIGHTS/METERS/SWITCHES
SERVICE INFORMATION
TROUBLESHOOTING
SWITCHES LOCATION
HEADLIGHT
IGNITION SWITCH/METER
HANDLEBAR SWITCHES
THERMOSTATIC SWITCH
18-1
18-2
18-2
18-3
18-4
18-6
18-7
TEMPERATURE SENSOR
TEMPERATURE GAUGE
FUEL PUMP
RELAY
FUEL PUMP
OIL PRESSURE SWITCH
NEUTRAL SWITCH
TURN SIGNAL RELAY
18-7
18-8
18-8
18-9
18-9
18-9
18-10
SERVICE INFORMATION







_
If the engine must be running to do some work, make sure the area is well-ventilated. Never run the engine in an enclosed area.
The exhaust contains poisonous carbon monoxide gas that may cause loss of consciousness and lead to death.
Gasoline is extremely flammable and is explosive under certain conditions. Work in a well ventilated area with the engine stopped.
Do not smoke or allow flames or sparks in the work area or where gasoline is stored.
GENERAL
• Some wires have different colored bands around them near the connector. These are connected to other wires which cor-
respond to the band color.
• All plastic connectors have locking tabs that must be released before disconnecting, and must be aligned when
reconnecting.
• To isolate an electrical failure, check the continuity of the electrical path through the part. A continuity check can usually
be made without removing the part from the motorcycle. Simply disconnect the wires and connect a continuity tester or
volt-ohmmeter to the terminals or connections.
• A continuity tester is useful when checking to find out whether or not there is an electrical connection between the two
points. An ohmmeter is needed to measure the resistance of a circuit, such as when there is a specific coil resistance in-
volved, or when checking for high resistance caused by corroded connections.
SPECIFICATIONS
Headlight 12 V 60 W/55 W
Brake/taillight
12 V 32/3 cp (27/8 W) x 2
Turn signal lights Front 12 V 32/3 cp (23/8 W) x 2
Rear
12 V 32 cp (23 W)
License light 12 V 4 cp
Indicator lights Turn signal 12 V 3 W
Neutral 12 V 3 W
High beem 12 V 3 W
Meter light 12 V 3.4 W x 1. 1.7 W x 2
Main fuse
30 A
Sub-fuse
10 A x 6. 15A x 1 (brake/turn/horn)
(fan, ignition, headlight, oil/neutral, brake/turn/horn, parking)
Fuel pump flow capacity/min
600 cc (0.630 US qt, 0.528 Imp qt)
TORQUE VALUES
Radiator thermostatic switch
Oil pressure switch
Ignition switch mounting bolt
18 N·m (1.8 kg-m, 13 ft-Ibl - Apply sealant to the threads
12 N·m (1.2 kg-m, 9 ft-Ibl - Apply sealant to the threads
25 N·m (2.5 kg-m, 18 ft-Ibl
18-1